Toyota Land Cruiser 100/Amazon, Lexus LX 470

since 1997 release

Repair and operation of the car



Toyota Land Cruiser, Amazon, Lexus LX470
+ Identification numbers of the car
+ Governing bodies and methods of safe operation of the car
+ Settings and routine maintenance of the car
+ Engine
+ Cooling systems of the engine, heating of salon and air conditioning
+ A power supply system and production of the fulfilled gases
+ Engine electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
- Gear shifting box
   + Automatic Transmission (AT)
   - Transfer case
      Removal and installation of the transfer case
+ Transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment





Removal and installation of the transfer case

Details of installation of the transfer case


 PERFORMANCE ORDER

1. The car also establish to Poddomkratta it on props.
2. Give 3 bolts of fastening of the protection cover of the transfer case and remove it.
3. Merge oil from the transfer case.
4. Remove forward and back driveshafts (see the Head the Transmission line).
5. Disconnect knot of draft of the drive of control of the transfer case (address an illustration above).
6. Remove a clamp, a washer, a wavy washer and the plug and disconnect knot of the shifting draft.
7. Turn out a bolt of the tire "weights" and remove it.
8. Prop up transmission a rack.

Not to damage the pallet, lay a piece of a board.

9. Give 8 bolts, 2 nuts and remove a cross beam.
10. Disconnect a ventilation hose, having remembered the provision of a clamp.
11. Disconnect the socket of the VSS sensor No. 1, 3 of the socket of sensors indicators of the mode of the transfer case and the socket of an electric motor of the actuation mechanism.
12. Slightly raise the transfer case and substitute under it a transmission rack.
13. Unfasten conducting from the transfer case.
14. Turn off 6 bolts of fastening of the adapter of a box and remove the transfer case down and back.
15. Installation is made upside-down. Track that all fixture was tightened according to requirements imposed in Specifications.