Toyota Land Cruiser 100/Amazon, Lexus LX 470

since 1997 release

Repair and operation of the car



Toyota Land Cruiser, Amazon, Lexus LX470
+ Identification numbers of the car
+ Governing bodies and methods of safe operation of the car
+ Settings and routine maintenance of the car
+ Engine
+ Cooling systems of the engine, heating of salon and air conditioning
+ A power supply system and production of the fulfilled gases
+ Engine electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
- Gear shifting box
   - Automatic Transmission (AT)
      Failure diagnostics of AT - the general information
      Adjustment of draft of gear shifting
      Check, adjustment and replacement of the sensor switch of permission of start
      Removal and installation of assembly of the lever of the AT selector
      Removal and installation of automatic transmission
   + Transfer case
+ Transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


08d33331



Adjustment of draft of gear shifting

 PERFORMANCE ORDER

1. Check freedom of movement of the executive lever when translating draft of switching from situation "P" in all other provisions of transmission, – if the indication of the indicator of the selector does not coincide with actually chosen situation, it is necessary to make adjustment of driving draft.
2. The car also establish to Poddomkratta it on props.
3. Weaken a nut of fastening of thirst of switching for the selector lever (address an accompanying illustration).
4. Wring out the hand lever on transmission (the small lever connecting draft of switching to a manual shaft in transmission) to the right against the stop, then return back it on two clicks, having transferred thereby to AT neutral situation.
5. Transfer the selector lever in interior of the car to situation "N".
6. Ask the assistant to fix the selector lever in situation "N" and from below tighten a nut of fastening of thirst of switching for it with the required effort.
7. Make adjustment of the sensor switch of permission of start (see the Section Check, adjustment and replacement of the sensor switch of permission of start).
8. Make sure of correctness of adjustment: the lever of the selector has to freely is transferred to each of the provisions provided by a design of the device, at the same time start of the engine has to become possible only in provisions "P" and "N" of the lever. In case of need repeat adjustment, trying to obtain performance of all listed above conditions.