Toyota Land Cruiser, Amazon, Lexus LX470 + Identification numbers of the car + Governing bodies and methods of safe operation of the car + Settings and routine maintenance of the car + Engine + Cooling systems of the engine, heating of salon and air conditioning + A power supply system and production of the fulfilled gases + Engine electric equipment + Control systems of the engine and decrease in toxicity of the fulfilled gases - Gear shifting box - Automatic Transmission (AT) Failure diagnostics of AT - the general information Adjustment of draft of gear shifting Check, adjustment and replacement of the sensor switch of permission of start Removal and installation of assembly of the lever of the AT selector Removal and installation of automatic transmission + Transfer case + Transmission line + Brake system + Suspension bracket and steering + Body + Onboard electric equipment
|
Check, adjustment and replacement of the sensor switch of permission of start
Check
|
The sensor switch provides a possibility of implementation of start of the engine only in two provisions of AT: "Р" and "N". If the engine is started in any other position of the lever, therefore, the sensor switch of permission of start is faulty, or its adjustment is broken. First of all it is necessary to check serviceability of a condition of the sensor switch. The faulty sensor switch is subject to replacement. |
|
Adjustment
|
1. Transfer the AT selector lever to situation "N". 2. The car also establish to Poddomkratta it on props.
|
3. Weaken a bolt of fastening of the sensor switch (address an accompanying illustration). |
4. Achieve combination of an adjusting groove from a basic risky neutral (address an illustration above). 5. Having fixed the sensor switch in the chosen situation, tighten a fixing bolt with the required effort. |
|
Replacement
|
1. If disturbs, remove a reception pipe of system of production of the fulfilled gases and the thermofilter (see the Head of the Power supply system and production of the fulfilled gases). 2. Release collars and disconnect oil cooler tubes. 3. Disconnect an electrical wiring from the sensor switch of permission of start. 4. Unbend a lock washer and give a fixing nut. 5. Turn out a bolt of fastening of the sensor switch (address an illustration above). 6. Remove the sensor switch. 7. Installation is made upside-down. Tighten fixture with the required effort. Do not forget to make adjustment of the sensor switch and to make sure of serviceability of its functioning. |
|
|
|