Toyota Land Cruiser 100/Amazon, Lexus LX 470

since 1997 release

Repair and operation of the car

Toyota Land Cruiser, Amazon, Lexus LX470
+ Identification numbers of the car
+ Governing bodies and methods of safe operation of the car
+ Settings and routine maintenance of the car
- Engine
   + Typical procedures of service of engines
   + Procedures of service of the petrol engine
   - Procedures of service of the diesel engine
      Removal, installation, dismantling and assembly of a head of cylinders
      Removal and installation of the inlet pipeline and final collector
      Removal, check of a state and installation of a belt of the GRM drive
      Removal and installation of cogwheels of the GRM drive
      Replacement of a forward epiploon of a bent shaft and epiploons of the camshaft and TNVD
      Replacement of a back epiploon of a bent shaft
      Removal and installation of camshafts and pushers of valves
      Removal and installation of the pallet of a case of the engine
      Removal, check of a state and installation of the oil pump
      Removal and installation of the oil cooler
      Removal and installation of a driving disk
+ Cooling systems of the engine, heating of salon and air conditioning
+ A power supply system and production of the fulfilled gases
+ Engine electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ Gear shifting box
+ Transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Removal and installation of the oil cooler

Components of assembly of the oil cooler are presented on an accompanying illustration.

Components of installation of the oil cooler

1 — an oil cooler Cover
2, 4, 6 — Laying
3 — the Backpressure valve
5 — the Oil cooler
7 — the Probe
8 — the Filter
9 — a probe Tube

10 — Consolidation of a tube
11 — the Stopper
12 — the Washer
13 — Pruzhina
14 — the Safety valve
15 — the Case of the safety valve
16 — the Drain stopper

PERFORMANCE ORDER

1. Merge OZh and remove an oil filter
2. Take off a gear belt and a cogwheel of TNVD.
3. Remove TNVD.
4. Take out the probe and remove its guide.
5. Give fixture and remove assembly of the oil cooler.
6. If necessary turn out the ECT sensor.
7. Give 4 nuts and separate a cover from the oil cooler.
8. Remove safety and return valves.
9. Installation is made upside-down. Tighten fixture with the required effort.