Toyota Land Cruiser 100/Amazon, Lexus LX 470

since 1997 release

Repair and operation of the car

Toyota Land Cruiser, Amazon, Lexus LX470
+ Identification numbers of the car
+ Governing bodies and methods of safe operation of the car
+ Settings and routine maintenance of the car
- Engine
   + Typical procedures of service of engines
   + Procedures of service of the petrol engine
   - Procedures of service of the diesel engine
      Removal, installation, dismantling and assembly of a head of cylinders
      Removal and installation of the inlet pipeline and final collector
      Removal, check of a state and installation of a belt of the GRM drive
      Removal and installation of cogwheels of the GRM drive
      Replacement of a forward epiploon of a bent shaft and epiploons of the camshaft and TNVD
      Replacement of a back epiploon of a bent shaft
      Removal and installation of camshafts and pushers of valves
      Removal and installation of the pallet of a case of the engine
      Removal, check of a state and installation of the oil pump
      Removal and installation of the oil cooler
      Removal and installation of a driving disk
+ Cooling systems of the engine, heating of salon and air conditioning
+ A power supply system and production of the fulfilled gases
+ Engine electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ Gear shifting box
+ Transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Replacement of a back epiploon of a bent shaft

PERFORMANCE ORDER

1. Remove AT or a basket of coupling (see the Head Korobk of gear shifting).
2. Remove a driving disk or a flywheel.

3. Remove a back plate of the engine (address an accompanying illustration).

4. Removal of an old epiploon can be made without preliminary dismantle of its case by a poddevaniye by its screw-driver, however, in order to avoid risk of damage of a pin of a bent shaft, authors of the present manual recommend to act according to the instructions stated below.

5. Turn out bolts of fastening of the case of an epiploon to the block and remove assembly, smooth out the interfaced surfaces from fragments of material of laying and old sealant (address an accompanying illustration).

6. Having laid the removed holder on a workbench on two wooden blocks, beat out an old epiploon a drift from the back party of a plate (address an illustration).

7. Wipe a nest under landing of an epiploon with acetone. Lay the holder on a flat firm surface and begin to knock a new epiploon in a nest, as a mandrel having used wooden whetstone or a piece of a pipe of suitable diameter.
8. Oil epiploon sponges pure motive.

9. Having accurately pressed the holder, put him on the regular place. Act without hurrying, watching that there was no wraparound of sponges of an epiploon at its putting on on a shaft pin (address an illustration). Screw fixing bolts and evenly tighten them with the required effort.

10. Further installation is made as it should be, the return to an order of dismantle of components.