Toyota Land Cruiser, Amazon, Lexus LX470
+ Identification numbers of the car
+ Governing bodies and methods of safe operation of the car
+ Settings and routine maintenance of the car
- Engine
+ Typical procedures of service of engines
+ Procedures of service of the petrol engine
- Procedures of service of the diesel engine
Removal, installation, dismantling and assembly of a head of cylinders
Removal and installation of the inlet pipeline and final collector
Removal, check of a state and installation of a belt of the GRM drive
Removal and installation of cogwheels of the GRM drive
Replacement of a forward epiploon of a bent shaft and epiploons of the camshaft and TNVD
Replacement of a back epiploon of a bent shaft
Removal and installation of camshafts and pushers of valves
Removal and installation of the pallet of a case of the engine
Removal, check of a state and installation of the oil pump
Removal and installation of the oil cooler
Removal and installation of a driving disk
+ Cooling systems of the engine, heating of salon and air conditioning
+ A power supply system and production of the fulfilled gases
+ Engine electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ Gear shifting box
+ Transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal and installation of the pallet of a case of the engine
Details of installation of the pallet of a case and oil pump
Removal
|
|
|
1. Elements of installation of the pallet of a case of the engine and oil pump are shown on an illustration above.
2. Remove GRM drive details (see the Section Removal and installation of cogwheels of the GRM drive).
3. Merge cooling liquid.
4. Merge motive oil and remove an oil filter.
5. Give case pallet fixture then separate it from the engine block, in case of need having accurately hooked it the small screw-driver or the pallet, try not to damage the interfaced surfaces.
6. If necessary remove a maslozabornik with laying.
|
|
Installation
|
|
1. Accurately scratch out all traces of sealant and material of old laying from the interfaced surfaces of the pallet and block. Carefully wipe the interfaced surfaces with the rags moistened in acetone. Clean a carving of deaf bolted openings in aluminum casting of the block.
2. Check a condition of the mesh filter of a maslozabornik, wash out solvent a maslozaborny tube, replace sealing laying, install assembly of a maslozabornik on the engine and with the required effort tighten fixing bolts.
3. If removed, establish into place a maslozabornik with new laying, tightening bolts of his fastening with the required effort.
|
|
4. Impose the roller of sealant 2 - 3 mm thick on the specified surfaces (address an accompanying illustration). |
5. Accurately press the pallet to the block of the engine and screw fixing bolts. Moving from the center outside, in three-four receptions tighten fixture with the required efforts.
6. Further installation is made as it should be, the return to an order of dismantle of components. Tighten fixture with the required effort. Do not forget to replace the filter and to add oil.
7. Start the engine and check the pallet for existence of signs of development of leaks. Check also oil pressure. |
|
|
|
