Toyota Land Cruiser 100/Amazon, Lexus LX 470

since 1997 release

Repair and operation of the car



Toyota Land Cruiser, Amazon, Lexus LX470
+ Identification numbers of the car
+ Governing bodies and methods of safe operation of the car
+ Settings and routine maintenance of the car
+ Engine
+ Cooling systems of the engine, heating of salon and air conditioning
+ A power supply system and production of the fulfilled gases
+ Engine electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ Gear shifting box
- Transmission line
   Specifications
   Driveshafts and hinges - the general information
   Check of a condition of the transmission line
   Removal and installation of the driveshaft
   Replacement of cardan hinges
   Driving shaft / half shafts, - the general information and check of a state
   Removal and installation of half shafts, bearings and epiploons of the back bridge
   Replacement of an epiploon of the leading gear wheel of differential
   Removal and installation of assembly of the back bridge
   Removal and installation of power shafts
   Replacement of protective covers and service of CV JOINTS
   Removal and installation of assembly of forward differential
   Removal and installation of naves with the switched-off drive
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


08d33331



Removal and installation of power shafts

Nave of a forward suspension bracket


 PERFORMANCE ORDER

1. Weaken wheel nuts, the car and install to a poddomkratta it on props. Remove the corresponding forward wheel.
2. Empty differential (see the Head Nastroyki and routine maintenance of the car).
3. Remove a brake support (see the Head the Brake system).
4. Remove a nave (see the Section Removal and installation of naves with the switched-off drive), then take a lock ring and throw off a remote washer (address an illustration above).
5. Having tapped through a brass drift, weaken landing of a shaft in assembly of a rotary fist.
6. Disconnect from a rotary fist the lower lever of a suspension bracket (see the Head Podvesk and steering).
7. Take away assembly of a fist outside and release an internal pin of a power shaft from assembly of differential, – in case of need tap a shaft the hammer with soft brisk for weakening of its landing in a side gear wheel.
8. Installation is made upside-down. Track reliability of tightening of a stupichny nut.