Toyota Land Cruiser 100/Amazon, Lexus LX 470

since 1997 release

Repair and operation of the car

Toyota Land Cruiser, Amazon, Lexus LX470
+ Identification numbers of the car
+ Governing bodies and methods of safe operation of the car
+ Settings and routine maintenance of the car
+ Engine
+ Cooling systems of the engine, heating of salon and air conditioning
+ A power supply system and production of the fulfilled gases
+ Engine electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ Gear shifting box
- Transmission line
   Specifications
   Driveshafts and hinges - the general information
   Check of a condition of the transmission line
   Removal and installation of the driveshaft
   Replacement of cardan hinges
   Driving shaft / half shafts, - the general information and check of a state
   Removal and installation of half shafts, bearings and epiploons of the back bridge
   Replacement of an epiploon of the leading gear wheel of differential
   Removal and installation of assembly of the back bridge
   Removal and installation of power shafts
   Replacement of protective covers and service of CV JOINTS
   Removal and installation of assembly of forward differential
   Removal and installation of naves with the switched-off drive
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Removal and installation of assembly of forward differential

Removal and installation

At the corresponding complete set block differential of the forward bridge.

Details of installation of assembly of forward differential


1 — the Right power shaft 2 — the Electrical wiring of the ADD sensor switch 3 — the Vacuum hose (models with ADD 4 — the Tube 5 — the Branch pipe of a sapun 6 — the Forward driveshaft 7 — Assembly of differential 8 — the Jellied stopper	9 — the Sealing washer 10 — the Pillow of a back support 11 — the Pillow of the right forward support 12 — the Sealing washer 13 — the Drain stopper 14 — the Lock ring 15 — the Pillow of the left forward support 16 — the Left power shaft

PERFORMANCE ORDER

1. Weaken wheel nuts, the car and install to a poddomkratta it on props. Remove forward wheels.
2. Remove protection of a case.
3. Merge from differential oil (see the Head Nastroyki and routine maintenance of the car).
4. Disconnect from assembly of forward differential the driveshaft (see the Section Removal and installation of the driveshaft) and tie up its forward end to car frame elements. Disconnect a branch pipe of a sapun, give a bolt of fastening of a vacuum tube and disconnect assembly of tubes from differential (address an illustration above).
5. Remove power shafts (see the Section Removal and installation of power shafts).
6. Prop up differential a transmission or cart jack and give fixture of support of differential.
7. Omit assembly of differential and take it from under the car, trying not to scratch the interfaced surfaces.
8. Installation is made upside-down.