Toyota Land Cruiser, Amazon, Lexus LX470
+ Identification numbers of the car
+ Governing bodies and methods of safe operation of the car
+ Settings and routine maintenance of the car
+ Engine
+ Cooling systems of the engine, heating of salon and air conditioning
+ A power supply system and production of the fulfilled gases
+ Engine electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ Gear shifting box
- Transmission line
Specifications
Driveshafts and hinges - the general information
Check of a condition of the transmission line
Removal and installation of the driveshaft
Replacement of cardan hinges
Driving shaft / half shafts, - the general information and check of a state
Removal and installation of half shafts, bearings and epiploons of the back bridge
Replacement of an epiploon of the leading gear wheel of differential
Removal and installation of assembly of the back bridge
Removal and installation of power shafts
Replacement of protective covers and service of CV JOINTS
Removal and installation of assembly of forward differential
Removal and installation of naves with the switched-off drive
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal and installation of half shafts, bearings and epiploons of the back bridge
Details of installation of a back half shaft and nave
|
|
1. Release the parking brake. A car back also establish to Poddomkratta it on props. Prop up forward wheels antiretractable boots. Details of installation of a half shaft are given on an illustration above.
2. On the equipped ABS models remove the wheel sensor. (See the Head the Brake system).
3. Remove assembly of the brake mechanism (see the Head the Brake system).
4. Disconnect a cable of the drive of the parking brake and the hydraulic line from the wheel cylinder (see the Head the Brake system).
5. Give four nuts of fastening of a back plate of a half shaft to a case of the back bridge.
6. Take a half shaft from a bridge case, try not to damage an epiploon.
7. Take from the flute in a face surface of a case a sealing ring.
|
|
8. Having hooked the big screw-driver, or having used the special tool, take a half shaft epiploon (address an accompanying illustration). |
9. Further dismantling of the back bridge demands use of special tools, including a hydraulic press and has to be charged to specialists of car service.
10. Having used a face head of the suitable size or a piece of a pipe of the corresponding diameter as a mandrel, put a new epiploon of a half shaft in a bridge case, grease epiploon sponges with universal lubricant.
11. Having slightly oiled, establish a new sealing ring.
12. Estimate a half shaft surface condition, remove teases and the agnails capable to lead to damage of an epiploon. Slightly oil a half shaft pure and fill it in a bridge case, try not to damage vents an epiploon.
13. Further installation is made as it should be the return to an order of dismantle of components. Track that nuts of fastening of a face plate were tightened with the required effort. |
|
|
|
