Toyota Land Cruiser 100/Amazon, Lexus LX 470

since 1997 release

Repair and operation of the car



Toyota Land Cruiser, Amazon, Lexus LX470
+ Identification numbers of the car
+ Governing bodies and methods of safe operation of the car
+ Settings and routine maintenance of the car
+ Engine
+ Cooling systems of the engine, heating of salon and air conditioning
+ A power supply system and production of the fulfilled gases
+ Engine electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ Gear shifting box
- Transmission line
   Specifications
   Driveshafts and hinges - the general information
   Check of a condition of the transmission line
   Removal and installation of the driveshaft
   Replacement of cardan hinges
   Driving shaft / half shafts, - the general information and check of a state
   Removal and installation of half shafts, bearings and epiploons of the back bridge
   Replacement of an epiploon of the leading gear wheel of differential
   Removal and installation of assembly of the back bridge
   Removal and installation of power shafts
   Replacement of protective covers and service of CV JOINTS
   Removal and installation of assembly of forward differential
   Removal and installation of naves with the switched-off drive
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


08d33331



Removal and installation of assembly of the back bridge

At the corresponding complete set block differential of the back bridge.


 PERFORMANCE ORDER

1. Weaken nuts of fastening of back wheels. The car also establish to Poddomkratta it on the props got under the bearing frame, not under the back bridge). Prop up forward wheels antiretractable boots. Remove back wheels.
2. Get a jack under a case of differential of assembly of the back bridge.
3. Disconnect the driveshaft from differential (see the Section Removal and installation of the driveshaft) and tie up it aside to frame elements. Remove half shafts (see the Section Removal and installation of half shafts, bearings and epiploons of the back bridge).
4. Disconnect all brake lines fixed on it from a bridge case. At once to a zakuporta open ends of tubes and hoses.
5. Remove assemblies of back brake mechanisms (see the Head the Brake system).
6. Disconnect cables of the drive of the parking brake from brake mechanisms, then release cables from clamps on a case of the back bridge (see the Head the Brake system).
7. Disconnect from a case of the back bridge and tie up aside a ventilating hose.
8. Remove shock-absorbers from basic arms on a bridge case, squeeze them and take aside.
9. Disconnect a bar of the stabilizer of cross stability, a cross jet bar, the top and lower levers of a suspension bracket (see the Head Podvesk and steering).
10. Lower the jack got under differential and take assembly of the back bridge from under the car.
11. Installation is made upside-down. Track that all fixture of elements of a suspension bracket was tightened with the required effort (see the Head Podvesk and steering).
12. Pump over the brake system (see the Head the Brake system).