Toyota Land Cruiser, Amazon, Lexus LX470
+ Identification numbers of the car
+ Governing bodies and methods of safe operation of the car
+ Settings and routine maintenance of the car
+ Engine
+ Cooling systems of the engine, heating of salon and air conditioning
- Power supply system and production of the fulfilled gases
Specifications
Dropping pressure in a power supply system
Check of serviceability of functioning of the fuel pump, measurement of pressure of fuel
Check of a state and replacement of fuel lines and their nipple connections
Removal and installation of the fuel tank
Cleaning and repair of the fuel tank - general information
Removal and installation of the fuel pump
Replacement of the sensor of fuel consumption
Removal and installation of assembly of the air cleaner
Removal, installation and adjustment of a cable of an accelerator
System of electronic injection of fuel (EFI) - the general information
Check of serviceability of functioning of system of electronic injection
Check of a state and replacement of components of system of injection
System of release - the general information
Removal and installation of nozzles
+ Engine electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ Gear shifting box
+ Transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
System of release – the general information
|
|
It is necessary to start service of system of release only after full cooling of its components, remember that the surface of the catalytic converter in use of the car can heat up to very high temperatures! Track reliability of fixing of the car in the lifted situation.
|
Typical design of system of production of the fulfilled gases
Replacement of components of system of production of the fulfilled gases consists mainly in dismantle and installation of thermoprotective screens / a detachment and connection of sections of assembly (address an illustration above). It is necessary to remember that thermofilters and rubber suspensions of basic arms have to be installed at assembly strictly on the former places. In view of the fact that in use the car components of system of production of the fulfilled gases constantly are exposed to aggressive influences of the environment and high temperatures, components of assembly can be "tightly stuck" to each other therefore before starting fixture otpuskaniye, it is necessary to impregnate joints of the corresponding sections with the getting oil. In especially hard cases it is necessary to use a hacksaw, a chisel or autogenous cutting.
|
|
