Toyota Land Cruiser 100/Amazon, Lexus LX 470

since 1997 release

Repair and operation of the car



Toyota Land Cruiser, Amazon, Lexus LX470
+ Identification numbers of the car
+ Governing bodies and methods of safe operation of the car
+ Settings and routine maintenance of the car
+ Engine
+ Cooling systems of the engine, heating of salon and air conditioning
- Power supply system and production of the fulfilled gases
   Specifications
   Dropping pressure in a power supply system
   Check of serviceability of functioning of the fuel pump, measurement of pressure of fuel
   Check of a state and replacement of fuel lines and their nipple connections
   Removal and installation of the fuel tank
   Cleaning and repair of the fuel tank - general information
   Removal and installation of the fuel pump
   Replacement of the sensor of fuel consumption
   Removal and installation of assembly of the air cleaner
   Removal, installation and adjustment of a cable of an accelerator
   System of electronic injection of fuel (EFI) - the general information
   Check of serviceability of functioning of system of electronic injection
   Check of a state and replacement of components of system of injection
   System of release - the general information
   Removal and installation of nozzles
+ Engine electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ Gear shifting box
+ Transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment





Removal and installation of the fuel tank

See preventions at the beginning of the Section Dropping Pressure in a power supply system.

Details of installation of the fuel tank


 PERFORMANCE ORDER

1. For the purpose of dumping of excessive pressure in a tank uncover a jellied mouth.
2. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that you have the correct combination for input of the audio system in action!

3. The car also establish to Poddomkratta it on props.
4. Turn out a drain stopper and lower fuel in the prepared capacity of suitable volume (address an illustration above).
5. Disconnect an electrical wiring of the fuel pump / sensor of fuel consumption and remove them.
6. Remove the protective pallet of the fuel tank.
7. Disconnect fuel pipes and the line of return of fuel evaporations.

Each of the mentioned lines has unique diameter that guarantees unambiguity of their connection at assembly. In case of doubts mark the disconnected components. At once to a zakuporta open ends of tubes.

8. Turn out fixing screws and disconnect a jellied mouth and a ventilating tube of the fuel tank.
9. Prop up a tank a cart jack, for distribution of loading having laid wooden whetstone between a head of the last and a bottom of a tank.
10. Release fixture and lower assembly brackets of fastening of a tank then smoothly lower a tank down.
11. Installation is made upside-down. Track that tubes and hoses were not pressed.