Toyota Land Cruiser 100/Amazon, Lexus LX 470

since 1997 release

Repair and operation of the car

Toyota Land Cruiser, Amazon, Lexus LX470
+ Identification numbers of the car
+ Governing bodies and methods of safe operation of the car
+ Settings and routine maintenance of the car
+ Engine
+ Cooling systems of the engine, heating of salon and air conditioning
- Power supply system and production of the fulfilled gases
   Specifications
   Dropping pressure in a power supply system
   Check of serviceability of functioning of the fuel pump, measurement of pressure of fuel
   Check of a state and replacement of fuel lines and their nipple connections
   Removal and installation of the fuel tank
   Cleaning and repair of the fuel tank - general information
   Removal and installation of the fuel pump
   Replacement of the sensor of fuel consumption
   Removal and installation of assembly of the air cleaner
   Removal, installation and adjustment of a cable of an accelerator
   System of electronic injection of fuel (EFI) - the general information
   Check of serviceability of functioning of system of electronic injection
   Check of a state and replacement of components of system of injection
   System of release - the general information
   Removal and installation of nozzles
+ Engine electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ Gear shifting box
+ Transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Removal and installation of the fuel pump

See preventions at the beginning of the Section Dropping Pressure in a power supply system.

The components which are subject to removal for access to the fuel pump

Details of installation of assembly of the fuel pump / sensor of fuel consumption

Removal

PERFORMANCE ORDER

1. Dump pressure in a power supply system (see the Section Dropping Pressure in a power supply system).
2. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that you have the correct combination for input of the audio system in action!

3. For access to the pump in salon, under a back rug, there is a removable cover (address an illustration above).
4. Remove back seats, having turned out their fixing bolts, previously having uncovered with them.
5. Remove an overlay of a threshold, a side overlay and an overlay of a step. Then remove carpets.
6. Uncover the technological hatch.

7. Disconnect fuel lines from a pump arm, previously having removed from them dirt (address an accompanying illustration).

8. Give eight screws and carefully take assembly of the pump with fuel consumption sensor from a gasoline tank (address an accompanying illustration). Laying can be thrown out – for installation it will be required new.

Try not to bend a sensor float leg.

9. Release the lower section of pump assembly from a basic arm (address an illustration of the Detail of installation of assembly of the fuel pump / sensor of fuel consumption). Disconnect an electrical wiring from assembly of the fuel pump / sensor of fuel consumption and remove a fuel hose.
10. Remove rubber consolidation and a lock ring of fastening of the mesh filter of a toplivozabornik.
11. Remove the mesh filter and estimate extent of its pollution, in case of need make replacement.

Installation

PERFORMANCE ORDER

Installation is made upside-down. Do not forget to replace sealing laying of a landing flange, at the corresponding complete set replace both sealing washers of a hollow bolt of the nipple socket. Tighten fixture with the required effort.