Toyota Land Cruiser 100/Amazon, Lexus LX 470

since 1997 release

Repair and operation of the car



Toyota Land Cruiser, Amazon, Lexus LX470
+ Identification numbers of the car
+ Governing bodies and methods of safe operation of the car
+ Settings and routine maintenance of the car
+ Engine
+ Cooling systems of the engine, heating of salon and air conditioning
- Power supply system and production of the fulfilled gases
   Specifications
   Dropping pressure in a power supply system
   Check of serviceability of functioning of the fuel pump, measurement of pressure of fuel
   Check of a state and replacement of fuel lines and their nipple connections
   Removal and installation of the fuel tank
   Cleaning and repair of the fuel tank - general information
   Removal and installation of the fuel pump
   Replacement of the sensor of fuel consumption
   Removal and installation of assembly of the air cleaner
   Removal, installation and adjustment of a cable of an accelerator
   System of electronic injection of fuel (EFI) - the general information
   Check of serviceability of functioning of system of electronic injection
   Check of a state and replacement of components of system of injection
   System of release - the general information
   Removal and installation of nozzles
+ Engine electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ Gear shifting box
+ Transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment



Replacement of the sensor of fuel consumption

See preventions at the beginning of the Section Dropping Pressure in a power supply system.


 PERFORMANCE ORDER

1. Accurately take assembly of the fuel pump / sensor of fuel consumption from the fuel tank (see the Section Removal and installation of the fuel pump), try not to damage a float of the sensor and the mesh filter of a toplivozabornik.
2. Disconnect an electrical wiring from assembly.
3. Turn out the screw, an assembly bracket of the sensor and take the last from assembly of a basic arm.
4. Installation is made upside-down. Do not forget to replace sealing laying of a landing flange of assembly.