Toyota Land Cruiser, Amazon, Lexus LX470
+ Identification numbers of the car
+ Governing bodies and methods of safe operation of the car
+ Settings and routine maintenance of the car
+ Engine
+ Cooling systems of the engine, heating of salon and air conditioning
+ A power supply system and production of the fulfilled gases
+ Engine electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ Gear shifting box
+ Transmission line
+ Brake system
- Suspension bracket and steering
Specifications
Removal and installation of forward shock-absorbers
Removal and installation of the forward stabilizer of cross stability
Removal and installation of assembly of a rotary fist with a nave
Check of a state and replacement of spherical support
Removal and installation of the torsion bars
Removal and installation of the top managing director of the lever of a forward suspension bracket
Removal and installation of the lower managing director of the lever of a forward suspension bracket
Removal and installation of back shock-absorbers
Removal and installation of a bar of the back stabilizer of cross stability
Removal and installation of a jet bar
Removal and installation of a screw spring of a back suspension bracket
Removal and installation of levers of a back suspension bracket
Removal and installation of a steering wheel
Check of a state, removal and installation of drafts of the steering drive
Replacement of protective covers of assembly of the steering mechanism
Removal and installation of the steering mechanism
Removal and installation of the steering pump
Removal of air from a hydraulic path of system of strengthening of a wheel
Wheels and tires - the general information
Angles of installation of wheels
+ Body
+ Onboard electric equipment
|
Removal and installation of a screw spring of a back suspension bracket
|
|
1. Prop up forward wheels antiretractable boots. A car back also establish to Poddomkratta it on props.
2. Prop up assembly of the back bridge a cart jack.
3. Pass a safety chain through rounds of a spring and you sboltit among themselves its ends, having eliminated with that risk of a casual vyskakivaniye of a spring in the course of lowering of assembly of the back bridge, track that the chain had a sufficient stock on length to allow a spring to be straightened completely.
4. Give a bolt of the lower fastening of the left back shock-absorber (see the Section Removal and installation of back shock-absorbers).
5. Disconnect from the back bridge a bar of the stabilizer of cross stability (see the Section Removal and installation of a bar of the back stabilizer of cross stability).
6. Give a bolt of the lower fastening of the right back shock-absorber (see the Section Removal and installation of back shock-absorbers).
7. Disconnect from the back bridge a jet bar (see the Section Removal and installation of a jet bar).
8. Slowly omit assembly of the back bridge, having provided sufficient free space for removal of a spring, try not to damage brake lines.
9. Installation is made upside-down. Track correctness of landing of an end face of a spring in a saddle. Tighten all fixture with the required effort. |
|
|
|
