Removal and installation of levers of a back suspension bracket
Components of installation of levers of a back suspension bracket
|
|
1. Components of installation of the stabilizer of cross stability are given on an illustration above.
2. Prop up forward wheels antiretractable boots. A car back also establish to Poddomkratta it on props.
3. Prop up the back bridge a cart jack.
4. On the equipped ABS models release an electrical wiring of the wheel sensor from basic arms on assembly of the top levers.
|
|
5. Give nuts, throw off washers and take bolts of fastening of the top levers of a suspension bracket to a frame and assembly of the back bridge (address an accompanying illustration). |
|
|
6. Give nuts, throw off washers and take bolts of fastening of the lower levers of a suspension bracket to a frame and assembly of the back bridge (address an accompanying illustration). |
7. Estimate a condition of rubber plugs of the lever. Make replacement of defective plugs in the conditions of a workshop of car service.
8. Installation is made upside-down. Track that all fixture was tightened with the required effort. Fixture you make tightening after lowering of the car on the earth. |
|
|
