Toyota Land Cruiser 100/Amazon, Lexus LX 470

since 1997 release

Repair and operation of the car

Removal and installation of the steering pump

Pump GUR arrangement

Components of assembly of the pump GUR

PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that you have the correct combination for input of the audio system in action!

2. Remove assembly of the air cleaner (see the Head of the Power supply system and production of the fulfilled gases).
3. Take off a driving belt (see the Head Nastroyki and routine maintenance of the car).
4. Get drain capacity under assembly of the steering pump. Disconnect pressure head and returnable lines of a hydraulic path from a back part of the pump (address the illustration Pump GUR Arrangement). At once to a zakuporta the open ends of lines in order to avoid hit in system of dirt.
5. If the pump is subject to replacement, remove from it a driving pulley.

Dismantle of a pulley can be made on a workbench after removal of the pump from the car.

6. Give fixture and take assembly of the steering pump from a motive compartment, try not to allow a spillage of hydraulic liquid on the painted body surfaces.
7. Components of assembly of GUR are presented on an illustration Components of assembly of the pump GUR.
8. Installation is made upside-down. Track that the corresponding fixture was tightened with the required effort.
9. Fill in in the tank of the steering pump the required amount of hydraulic liquid of the corresponding grade (see the Head Nastroyki and routine maintenance of the car), then pump over system of hydrostrengthening of a wheel (see the Section Removal of Air from a hydraulic path of system of strengthening of a wheel).