Toyota Land Cruiser 100/Amazon, Lexus LX 470

since 1997 release

Repair and operation of the car



Toyota Land Cruiser, Amazon, Lexus LX470
+ Identification numbers of the car
+ Governing bodies and methods of safe operation of the car
+ Settings and routine maintenance of the car
+ Engine
+ Cooling systems of the engine, heating of salon and air conditioning
+ A power supply system and production of the fulfilled gases
+ Engine electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ Gear shifting box
+ Transmission line
+ Brake system
- Suspension bracket and steering
   Specifications
   Removal and installation of forward shock-absorbers
   Removal and installation of the forward stabilizer of cross stability
   Removal and installation of assembly of a rotary fist with a nave
   Check of a state and replacement of spherical support
   Removal and installation of the torsion bars
   Removal and installation of the top managing director of the lever of a forward suspension bracket
   Removal and installation of the lower managing director of the lever of a forward suspension bracket
   Removal and installation of back shock-absorbers
   Removal and installation of a bar of the back stabilizer of cross stability
   Removal and installation of a jet bar
   Removal and installation of a screw spring of a back suspension bracket
   Removal and installation of levers of a back suspension bracket
   Removal and installation of a steering wheel
   Check of a state, removal and installation of drafts of the steering drive
   Replacement of protective covers of assembly of the steering mechanism
   Removal and installation of the steering mechanism
   Removal and installation of the steering pump
   Removal of air from a hydraulic path of system of strengthening of a wheel
   Wheels and tires - the general information
   Angles of installation of wheels
+ Body
+ Onboard electric equipment


08d33331



Removal and installation of the steering mechanism

The models of cars considered in the present manual are equipped with system of additional safety (SRS). Before starting performance of any works near the block of a safety cushion, a steering column or the dashboard, disconnect SRS in order to avoid getting injured at its casual operation (see. Onboard electric equipment). It is easy to distinguish an electrical wiring of a chain of SRS on yellow color of isolation. In order to avoid damage of the SRS system, Track that the steering shaft was not turned after removal of a steering wheel. Block a column the ignition key at the rectilinear provision of forward wheels.


Components of assembly of the steering mechanism


Components of installation of the steering mechanism


 PERFORMANCE ORDER

1. Park the car with the forward wheels developed in rectilinear situation. Cock the parking brake. Weaken wheel nuts, a front of the car and establish to a poddomkratta it on props. Remove forward wheels and protection of a case.
2. Disconnect side steering drafts from rotary fists (see the Section Check of a State, removal and installation of drafts of the steering drive).
3. Remove a bar of the stabilizer of cross stability (see the Section Removal and installation of the forward stabilizer of cross stability).
4. Mark the provision of an intermediate shaft of rather steering mechanism and turn out a through bolt of the connecting cardan hinge of a steering shaft.
5. Disconnect pressure head and returnable lines of a hydraulic path from a case of the steering mechanism (address an illustration Components of assembly of the steering mechanism).
6. Turn out fixture (With and D) an assembly bracket on the right side of assembly, give a nut and take a through bolt (B) at the left. In conclusion turn out a bolt (A) (address an illustration Components of installation of the steering mechanism).
7. Remove assembly of the steering mechanism from the car.
8. If at the removed steering mechanism for any reason the provorachivaniye of a steering shaft was made, remove a steering wheel and center a contact drum of a safety cushion (see the Section Removal and installation of a steering wheel).
9. Installation is made upside-down. Track that all fixture was tightened with the required effort.
10. In conclusion pump over the GUR system (see the Section Removal of Air from a hydraulic path of system of strengthening of a wheel).