Removal and installation of the forward stabilizer of cross stability
Components of installation of the forward stabilizer of cross stability
|
|
1. The car also establish to Poddomkratta it on props. At the corresponding complete set remove protection of a case.
2. Give nuts (address an illustration above) and take bolts of fastening of racks of the stabilizer of cross stability.
3. Give bolts/nut of collars of fastening of a bar of the stabilizer of cross resistance to a car frame.
4. Take a bar of the stabilizer of cross stability from under the car and remove from it rubber plugs.
5. Estimate a condition of plugs, in case of need make their replacement.
6. At installation of new plugs, track that they were deployed by cuts on the car forward.
7. Installation is made upside-down. Track that all fixture was tightened with the required effort (address an illustration above). |
|
|
