Toyota Land Cruiser 100/Amazon, Lexus LX 470

since 1997 release

Repair and operation of the car

Toyota Land Cruiser, Amazon, Lexus LX470
+ Identification numbers of the car
+ Governing bodies and methods of safe operation of the car
+ Settings and routine maintenance of the car
+ Engine
+ Cooling systems of the engine, heating of salon and air conditioning
+ Power supply system and production of the fulfilled gases
- Engine electric equipment
   Start of the engine from the auxiliary power supply
   Removal and installation of the rechargeable battery
   Check of a state and replacement of wires of the battery
   System of ignition - the general information and precautionary measures (petrol models)
   Check of functioning of system of ignition
   Replacement of the coil of ignition
   Check and adjustment of installation of a corner of an advancing of ignition/injection of fuel of the petrol engine
   Replacement of the module of ignition
   System of a charge - the general information and precautionary measures
   Check of a condition of system of a charge
   Removal and installation of the generator
   Check of a state and replacement of components of the generator
   System of start - the general information and precautionary measures
   Check of serviceability of functioning of a starter and chain of start
   Removal and installation of a starter
   Removal and installation of the traction relay
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ Gear shifting box
+ Transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


Removal and installation of the generator

Details of installation of the generator


1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that you have the correct combination for input of the audio system in action!

2. Merge cooling liquid.
3. Take off a generator drive belt.
4. Remove protection of a case and a radiator.
5. Remove a pump GUR pulley.
6. Mark the electrical wirings and tires of grounding brought to the generator and disconnect them from assembly.
7. Turn out adjusting and axial bolts, and also a lock nut from an adjusting level of the generator (address an illustration above).
8. When replacing the generator take the block removed from the engine in shop, – replaceable has to correspond in accuracy to it on a standard size, plugs have to have identical marking, the size and an arrangement, the identification marking which is beaten out on the case, or put on Schild has to coincide.
9. The new / restored generators can be delivered on the market without driving pulley, – in that case the last should be rearranged from old assembly.
10. Installation is made upside-down.
11. In conclusion adjust effort of a tension of a driving belt (see the Head Nastroyki and routine maintenance of the car) and check charge tension (see the Section Check of a Condition of System of a Charge).