1. Disconnect negative from the battery both wires (at first negative).
2. Remove a steering wheel (see the Head Podvesk and steering).
3. Remove the central section of finishing of the dashboard (see the Head Kuzov).
4. Turn out fixing screws (address an illustration above), take a combination of devices from the landing nest and disconnect an electrical wiring.
5. Remove protective glass.
6. Having removed cartridges of lamps and having turned out screws of fastening of the printed circuit board, remove the last from the back party of a combination of devices.
7. Turn out screws of fastening of devices and remove devices.
8. Installation is made upside-down. Do not forget that the negative wire is always connected to the battery in the last turn. |
|
